Troubleshooting: Installation did not start when double click on AutoCount Setup file/Installer
Question : When I double click on AutoCount setup file, nothing happens! Even I copy/download the setup file and run again, installation still do not start. Why?
Possible Reason :
The setup file/installer being blocked.
1) Right click on the setup file/installer and select for Properties.
2) Check the checkbox of Unblock and then click on Apply and OK.
3) You should able to run the setup now.
Note : Please seek assistance from your software dealer if the problem still persists after performing the steps as above.
By : Lay Swan 181114, P181119
|AutoCount Accounting 2.0
|AutoCount Accounting 1.8 / 1.9
|AutoCount On The Go
|AutoCount Accounting Plug-In Documentations